Check The Tub Cover Gasket During DIY Appliance Repair In Oakville

Facing with an issue with your washing machine can set panic in your home, especially when you see it spraying water in your home or leaking continuously. You can call a professional for Appliance Repair in Oakville or, if you want to save money, try some DIY basic repairs. You can start your repair venture by checking a few components and one of the most significant parts of a leaking washer to check, is the tub cover gasket. Every different model of washing machine will have different specifics of the tub gaskets that you must keep in mind, during the repairing process.

Functions of the Tub Cover Gasket

The use of the tub cover gasket on a washer whether it is a top load model or a front load washer is to provide a seal that fits in between the inner and outer tub. If this gasket is damaged then there will be a gap that will result in a water leak. The spin or wash portions of the cycle will not be proper and water will come out from the tub during the process. You can water leaks and soapy water stains will be clearly visible in this area and therefore diagnosing such a problem will not be very difficult for you during Appliance Repair in Oakville.

Check the Valve for Water Inlet

You must also check the water inlet valve, during Appliance Repair in Oakville. You can simply raise the top or remove the front panel to look into this area. This valve is used to regulate the entry of hot or cold water into the washing machine. This valve is normally located at the rear of the washing machine. This is the place where the drain and fill hoses connect with the tub. A defective water inlet valve will result in a leak from the back of your washing machine during the filling cycle.

Look For Signs of Damages

You must also look for signs and symptoms of damages while inspecting the body of the filling valve. There may also be a few signs of cracks which will signify that it is high time that you replace it. The door boot seal or the bellows may also be damaged. These are usually found in the front load washing machines and are used to seal between the outer tub and the door. The rubber bellows may crack due to normal wear and tear or even any foreign objectmay rip and tear the bellows. This will cause a leak in the washing machine asking for immediate Appliance Repair in Oakville.

Leaks near The Door Area

If the washing machine is found to be leaking water near the door area, then the broken bellows may be the culprit and needs to be replaced. Open the door to inspect these bellows for any signs of damage. Also look for any dirt or buildup of detergent on the door seal preventing proper locking. Be careful as there may be sharp foreign objects in the folds of these bellows to prevent any hazard. To read more Click Here